When an e-bike loses assist, riders often replace expensive parts first. Work this tree instead. It catches the majority of field failures without guesswork.

Safety first

Remove the battery before disconnecting motor phase plugs or probing connectors. Support the bike securely. If you smell burning insulation or see melted connectors, stop and use a qualified technician.

Step 0 — define the symptom precisely

Write down:

  • No power at all vs power with no assist
  • Fails only under load vs fails immediately
  • Wet weather only?
  • Any display code or blink pattern?
  • Recent work (flat tire, wash, crash, upgrade)?

Step 1 — battery and key basics

  1. Charge with the correct charger until the charger indicates completion.
  2. Reseat the pack until locks / connectors fully engage.
  3. Try a known-good wall outlet.
  4. Check pack for swelling, impact damage, or moisture.

If the bike is dead at the display, stay on battery/power distribution until the display lights reliably. See battery not charging.

Step 2 — visible connectors and harness strain

Inspect and reseat:

  • Battery discharge connector
  • Display cable
  • Motor cable (hub or mid-drive)
  • Brake inhibitor plugs
  • Throttle plug if equipped

Look for green corrosion, pulled pins, and jacket wear at the stem, chainstay, and dropout exits. Intermittent cut-outs under load are often mechanical connector issues.

Step 3 — brake inhibitors

Squeeze each lever and watch whether assist behaves oddly. Unplug brake sensors one at a time (temporary diagnostic only) to see if a stuck inhibitor is killing power. Details: brake sensor issues.

Step 4 — display codes and mode settings

Confirm assist level is not zero, walk mode is not stuck, and speed/wheel-size settings were not reset after battery work. Record error codes before clearing them — they are diagnostic gold. See display errors.

Step 5 — throttle and pedal sensor path

  • Throttle bikes: test throttle with brake levers released and wheels safely elevated.
  • Cadence sensor magnets must align; missing magnets mean no assist.
  • Torque sensor bikes may need calibration after crank service — brand specific.

Guides: throttle problems, motor not engaging.

Step 6 — load-only failures

If the motor works lightly but dies climbing, suspect:

  • Battery voltage sag / weak cells
  • Undersized connectors heating
  • Controller thermal cutback
  • Loose phase pins under torque

See cutting out under load.

When to stop DIY

Seek a shop when:

  • You lack a torque arm on a high-power hub conversion and dropouts are spreading
  • Water reached the battery cells or controller
  • You are not equipped to measure connector integrity safely
  • The bike is under warranty that DIY voids

When to see a shop.

Prevent the next failure

  • Strain-relieve harnesses after tire changes
  • Keep charge ports capped
  • Service brakes so inhibitors stay aligned
  • Follow routine maintenance