Throttle Problems
Work the symptom tree: power → connectors → sensors → controller codes.

Power down first. Unplug the battery and wait a minute before probing connectors or controllers.
Likely causes
- Loose or corroded connectors at the battery, display, or motor cable
- Brake inhibitor engaged or misaligned
- Controller fault stored after a low-voltage cutout
Diagnostic steps
- Confirm the pack is charged and the key/power switch is fully seated.
- Inspect harness strain points near the bottom bracket, dropout, and stem.
- Note any display code and match it to your controller family chart.
- If the motor cuts only under load, check phase connectors and battery sag.