US riders · Transparent affiliate links · Expert-reviewed technical guidance US riders · Expert-reviewed guidance

Display Errors

Work the symptom tree: power → connectors → sensors → controller codes.

Rear dropout measured with a caliper on a workshop bench.
Reference photograph. Not a test sample.
Power down first. Unplug the battery and wait a minute before probing connectors or controllers.

Likely causes

  • Loose or corroded connectors at the battery, display, or motor cable
  • Brake inhibitor engaged or misaligned
  • Controller fault stored after a low-voltage cutout

Diagnostic steps

  1. Confirm the pack is charged and the key/power switch is fully seated.
  2. Inspect harness strain points near the bottom bracket, dropout, and stem.
  3. Note any display code and match it to your controller family chart.
  4. If the motor cuts only under load, check phase connectors and battery sag.

When to see a shop Maintenance checklist

Ride farther with better intel

Range tips, kit compatibility notes, and battery safety updates — practical, not promotional noise.